1.  Using Your Phillips Head Screwdriver, begin to remove the screws from the electrical box as shown in here.
Removing the Screws from the Electrical Box on the bottom of the Sculpture Base
2.  Separate the electrical kit from the base as shown.
Removing the Electrical Box from the Wooden Base
3.  Separate the two electrical connectors as shown.
Separating the wire connectors inside the electrical box
4.  As shown begin to remove the screws from the base.
Removing the screws from the Wood Base which holds the Sculpture

5.  This is an image of th complete sculpture removed from the wooden base.
The Sculpture Base After the Wood Base is separated